Leather Straps for hanging cushions, pillows, headboards. Real leather, custom sizing, colors and hardware

This is for one (1) leather strap. For hanging cushions, the amount needed will depend on weight, length of cushion and if you are anchoring into a wall.
Each strap is approximately 1.5” wide. The edges are finished/sealed and both sides are in finished leather (not the back side of leather - two good sides of leather are glued together, finished and then sewn to make the straps. The straps are then top-stitched around the perimeter about 1/4” from the edge.

The leather used is full grain aniline leather.

Unless otherwise requested a snap screw is included. The front of the strap, at the top will include the male snap which is already in place in your choice of either antique bronze (pictured), black, or copper. The male end of the snap which includes the screw and can be screwed into your wall, headboard, or cabinet, etc will be included. The screw portion is 5/8” long and may need to be anchored or go directly into studs depending on the weight of your cushions.

How to measure for your straps:
Take the height or depth of your cushion times 2 plus the thickness of your cushion times 2 plus add about 3 inches above that for the strap to sit above the cushion.
For instance, if my cushion is 15” tall and 2” thick:
15+15+2+2+3=37” in length for my straps

If hanging pillows then measure the circumference around the pillows and add about 3 inches or so or however much you want the straps to be above.

Straps can also be used purely ornamentally if cushions are held up with velcro or otherwise.

If you have preferences on stitching color please put that in the personalization area when checking out, otherwise a complimentary stitching will be used.

Please note that all straps are made to order so review turnaround times before ordering.